After the installation of Events2HVAC, you will need to configure the connection to the SmartService server.
1. Open the E2H client.
2. Select
Device Interface
àKantech
à Kantech Options.
(Note: If you don’t see this option, either you didn’t load the Kantech
SmartService interface during setup, or you need to rediscover your devices
using Device Interface Manager.)
3. On the
SmartService Options tab, enter the information specific to your
SmartService system. See the next section on SmartService interface options for
details about each field.
4. Test the connection by clicking on the Test Connection button. If it is successful, you are ready to start adding equipment.