Connection Type
1.
Directly connected with NetworkThermostat controllers via TCP/IP.
This setting will send RAW TCP commands directly to Net/X controllers or
to the NetX Port Sharing service.
2.
Connect with NetX Port Sharing Service via TCP Remoting.
This setting
will send commands to a proprietary TCP channel on the port sharing service.
[NOT IMPLEMENTED]
3. Connect with Net/X Web Service.
[NOT IMPLEMENTED]
Commands
|
Field Name |
Description |
Range |
|
Retries |
Number of attempts to retry any failed commands |
Default = 3 |
|
Retry Delay |
Number of milliseconds to delay before each retry. |
Default = 5000 ms |
|
Command Delay |
Number of milliseconds to delay between successive commands. |
Default = 0 ms Only applies to SetOccupied Actions. |
|
TCP Timeout |
Number of milliseconds to wait before a TCP send/receive is failed. |
Default = 1000 ms |
|
Send Single Commands |
Checked = Sends one command a time to the thermostat. Unchecked = package up multiple commands into one. (note: unchecked might cause delays that can cause Command Center to go offline) |
Default = Unchecked Note: this only applies to XBus/StrongMesh thermostats. |
Send Single Commands Checkbox
Select this option if you want send individual TCP api commands for each action. Unchecked (default) will group multiple api commands into a single TCP command where available.
Default Day (Occupied) Settings
|
Field Name |
Description |
Range |
|
Default Day Heating Setpoint |
Default setting for the heating setpoint during day mode. |
Default = 68 |
|
Default Day Cooling Setpoint |
Default setting for the cooling setpoint during day mode. |
Default = 72 |
|
Default Day HVAC Mode |
Default setting for the mode status during the day mode. |
Default = Auto Auto, Off, Cool, Heat |
|
Default Day Fan Mode |
Default setting for the fan mode status during day mode. |
Default=Auto Auto, On |
Default Night (Unoccupied) Settings
|
Field Name |
Description |
Range |
|
Default Night Heating Setpoint |
Default setting for the heating setpoint during night mode. |
Default=60 |
|
Default Night Cooling Setpoint |
Default setting for the cooling setpoint during night mode. |
Default=80 |
|
Default Night HVAC Mode |
Default setting for the mode status during the night mode. |
Default=Auto Auto, Off, Cool, Heat |
|
Default Night Fan Mode |
Default setting for the fan mode status during night mode. |
Default = Auto Auto, On |
LED Control
|
Field Name |
Description |
Range |
|
Enable LED For Occupied |
Lights up the selected LED on thermostat during occupied mode |
Default = Yes |
|
LED For Occupied |
Select which LED to turn on for occupied mode. Left (Green) is the recommended selection |
Left (Green) |
See also: Optional Occupied Mode LED Assignment for setup in the thermostat.
Note: LED control can only be used on stand-alone IP or WIFI thermostats (not XBus or StrongMesh)